Check-Manual von if64
Monitor Network Interfaces via Standard MIB Using 64-Bit Counters
Distribution | Official part of Checkmk |
---|---|
Lizenz | GPLv2 |
Unterstützte Agenten | SNMP |
interfaces
but uses 64-bit counters from
the IF-MIB
.1.3.6.1.2.1.31.1.1.1
. This allows to correctly
monitor switch ports with a traffic of more then 2GB per check interval.Also, this check can use ifAlias
instead if ifDescr
for retrieving
the admin-configured interface description. This is useful e.g. for HPE ProCurve
switches which do not show the aliasses in ifDescr
.
Note
: This check needs SNMP v2c and thus only works if your hosts are
added to bulkwalk_hosts
.
Depending on the check parameters, this check can go WARN or CRIT when the port status changes (i.e. is down), when the link speed changes (e.g. a port expected to be set to 1 GBit/s operates only at 100 MBit/s), when the absolute or procentual traffic of a port exceeds certain levels or if the rate of errors or discards exceeds configurable limits.
This check supports averaging the in- and outgoing traffic over a configurable time range by using an exponentially weighted moving average - just as Linux does for the CPU load averages. The averaging can be configured on a per-host and per-interface base. Interfaces with averaging turned on yield two additional performance values: the averaged in- and outgoing traffic in bytes. If you have configured traffic levels, then those levels are applied to the averaged values.
This check also supports monitoring of the administrative status (ifAdminStatus
),
however, by default, this option is deactivated to reduce SNMP traffic. To activate
the monitoring of the admin status, you have to configure Checkmk to fetch this
information. This is done by activating the section if64adm
via the rule
"Disabled or enabled sections (SNMP)", which will lead to an increase in SNMP
traffic of approximately 5%.
Note that there are some devices with broken firmware which report that
they support 64-bit counters even though they do not. In such cases, use the rule
"Disabled or enabled sections (SNMP)" to disable the section if64
. This will make
Checkmk fall back to the 32-bit interface check.
Item
There are three allowed ways to specify an interface: its index {ifIndex}, its description {ifDescr} and its alias {ifAlias}.
Discovery
One service is created for each interface that fulfills configurable conditions (rule "Network interface and switch port discovery"). By default, these are interfaces which are currently found {up} and are of type 6, 32, 62, 117, 127, 128, 129, 180, 181, 182, 205 or 229. {Grouping:} In some situations, you do not want to monitor a single interface but a group of interfaces that together form a pool. This check supports such pools by defining groups. The data of all members is accumulated and put together in a single grouped interface service.