Check manual page of apc_inrow_temp

APC InRow Cooling Devices: Temperature

Included in All Checkmk editions
Source Code License Open Source
Supported Agents SNMP
The current temperature of all sensors in an InRow Cooling device.

You can configure upper levels for WARN/CRIT (default: 30, 35).

The service goes WARN/CRIT if the temperature is higher than these levels.

This check uses the PowerNet-MIB.

Item

The current mode of the check (i.e. RackInlet, Supply Air, Return Air, Entering Fluid, Leaving Fluid).

Discovery

One service is created for each temperature sensor: Entering/Leaving Fluid, Supply/Return Air, Rack Inlet