Check manual page of apc_netbotz_sensors

APC Netbotz Devices: Temperature Sensor

Included in	All Checkmk editions
Source Code License	Open Source
Supported Agents	SNMP

This check monitors the temperature sensors of APC Netbotz devices which support the NETBOTZV2 MIB, e.g. Netbotz 450 series, or the NETBOTZ50 MIB, e.g. Netbotz 50.

It also monitors the wireless temperature sensors (NBWS100T, NBWS100H) of the Netbotz Rack Monitor series, e.g. Netbotz 250. Those devices report their wireless sensors via the wirelessSensorStatusTable of the PowerNet MIB instead of one of the Netbotz MIBs.

You can configure lower and upper levels for CRIT and WARN (default: WARN: 25, 30 CRIT: 20, 35)

The service goes WARN or CRIT if the temperature is higher than given upper levels or lower than the given lower levels. Otherwise it returns OK.

This check uses the NETBOTZV2-MIB, the NETBOTZ50-MIB and the PowerNet-MIB.

Item

The temperature sensor identifier. For wireless sensors this is the sensor name configured on the device, or Wireless sensor if the sensor has no name.

Discovery

One service is created for each temperature sensor.