Check manual page of cmciii_lcp_fans

Rittal CMC-III LCP: Fans

Included in	All Checkmk editions
Source Code License	Open Source
Supported Agents	SNMP

This check monitors the status and RPM (in precent of maximum RPM) of the fans of Rittal CMC-III LCP devices. No limits are set in the check, since limits are configured in the Rittal device itself. The state given by the Rittal device is taken as the state of the check as follows: If the Rittal device returns OK, the check is OK. Otherwise the check is CRIT. Futhermore, the global lower limit for the fan RPM is extracted from the device. If the fan RPM is below this limit, the check is WARN.

Firmware versions using the MIB of firmware V3.15.20 are supported.

Item

The number of the fan

Discovery

One service is created for each fan (6 per device) if their status is not "Off".