Check manual page of cmciii_lcp_waterflow

Rittal CMC-III LCP: Water Flow

Included in	All Checkmk editions
Source Code License	Open Source
Supported Agents	SNMP

This check monitors the water flow of Rittal CMC-III LCP devices. No limits are set in the check, since limits are configured in the Rittal device itself. The state given by the Rittal device is taken as the state of the check as follows: If the Rittal device returns OK, the check is OK. Otherwise the check is CRIT. Furthermore, the minimum and maximum flow limits of the device are extracted and a state of WARN is assumed if the actual flow is outside these limits.

Firmware versions using the MIB of firmware V3.15.20 are supported.

Discovery

One service is created.