Check manual page of juniper_alarm

Juniper Ethernet Switch: Chassis Alarm

Included in All Checkmk editions
Source Code License Open Source
Supported Agents SNMP
This check monitors the alarm state of a Juniper Ethernet Switch Chassis.

The device sends the state by itself:

- OK, good, normally working: OK - alarm, warning, marginally working (minor): WARN - alert, failed, not working (major): CRIT - unknown or unavailable: UNKNOWN - OK, online as an active primary: OK - alarm, offline, not running (minor): WARN - off-line, not running: CRIT - entering state of ok, good, normally working: OK - entering state of alarm, warning, marginally working: WARN - entering state of alert, failed, not working: CRIT - entering state of ok, on-line as an active primary: OK - entering state of off-line, not running: WARN

The device status to state mapping can be configured in the __State of Juniper Alarms__ rule.

Discovery

One service is created.