Check manual page of tinkerforge_motion

Tinkerforge Sensor Bricklet: Motion Detectors

Distribution	Official part of Checkmk
License	GPLv2
Supported Agents	Special

This check monitors motion detector bricklets on any tinkerforge stack. For this check the time ranges during which movement shouldn't occur can be configured. Outside these times, a motion would be mentioned in the infotext but the state remains OK. Please note that the sensor has two hardware "wheels" to control its sensitivity and how long, after motion ended, the motion detector will remain in its warning states. check_mk can not influence these values.

Item

The bricks position inside the stack.

Discovery

One service is created for each motion detector bricklet.